Technology KnowledgeBase

How do I calibrate my ActivBoard for Inspire?

With both the ActivBoard and the computer switched on, hold the ActivPen lightly on the ActivBoard, without pushing in the ActivPen nib. The cursor, on the ActivBoard, should line up with the tip of the ActivPen. If it does not, you need to calibrate the ActivBoard using the steps below.

There are two ways to calibrate your ActivBoard. How you calibrate the ActivBoard depends on the type of ActivBoard you have:

Method 1

  1. Hover the ActivPen over the Calibration light in the top-left corner of the ActivBoard for a few seconds.
  2. Follow the on-screen instructions.

Method 2

  1. Click on the ActivManager icon in the upper right-hand corner of the display in the Finder menubar (the very top menubar that shows the day and time) to reveal the drop down menu.
  2. Select Calibrate.
  3. Follow the on-screen instructions.
  4. Check that the tip of your ActivPen lines up with the cursor on the ActivBoard. If it does not, try Method 3 below.

After calibrating, check that the tip of your ActivPen lines up with the cursor on the ActivBoard. If it does not, reset the board by switching it off for thirty seconds. Then switch it on and try calibrating again, or contact technical support.

Attached Files
There are no attachments for this article.
MENU