Technology KnowledgeBase
Home » Categories » Projectors, Document Cameras, and Other AV

The projected image when using the document camera doesn’t fill the entire screen.

Article ID: 603 | Rating: Unrated | Last Updated: Thu, Jan 19, 2017 at 7:20 AM

There is a setting on one of the switches on the document camera that can cause the image to project with a black border at the top and the bottom of the screen.

 
Look at the side of your doc cam and you'll see two black switches. If the leftmost switch is set to the left position, push it to the middle or right position. The top and bottom borders on the projected image should disappear.
 
Posted by: - Wed, Jun 26, 2013 at 12:33 PM.
Filed Under: Projectors, Document Cameras, and Other AV
Attached Files
There are no attachments for this article.
Related Articles
My Avervision software does not work with my document camera.
Added on Wed, Aug 26, 2009
My Sound System is not working properly. What can I do to check that it is set up correctly?
Added on Mon, Jun 29, 2009
When is it best to blank/AV mute vs turn the projector off?
Added on Mon, Jun 29, 2009
Why is my projector not recognizing my computer? Error says: "No Input Detected".
Added on Mon, Jul 6, 2009
How do I change my screen resolution (screen size) on my Mac when connected to an active board or flat panel display?
Added on Tue, Jun 30, 2009
The projected image on my whiteboard isn’t right - the image on the screen is red (or blue or purple or fuzzy or blurry).
Added on Wed, Jul 8, 2009
How do I clean my projector filter?
Added on Mon, Jun 29, 2009
Where can I download a users manual for my projector?
Added on Mon, Jun 29, 2009
What should I do if the filter timer reset message appears on my screen?
Added on Mon, Jun 29, 2009
How can I extend the life of my bulb?
Added on Mon, Jun 29, 2009
MENU
0 (0)
Article Rating (No Votes)
Rate this article